Remove Pins In Cross Drive Anchors

Phil shows you how to take out the pins in a cross drive anchor system if you ever need to.

⏱️⏱️Chapters⏱️⏱️
00:00 Intro
00:12 If you want to take out the pins in cross drive
00:30 You want a longer pipe wrench than what he's got
00:50 If you try to use a wench or truck you'll end up with...

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: [email protected]
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

#mobilehomeanchors #crossdriveanchors #anchors

Transcript:
All right. To note, if you want to take out the pins in a cross drive system, you have to use a pipe wrench and you really.

You take your hammer, your sledge hammer and your hammer, loosen it, and then you take your. Your a longer one than this, but you tighten it up where it starts to get where it starts, tighten on the pin and then start pulling up and twisting it. And you're loosening the dirt, and you're twisting it inside that hole and pulling it out at the same time.

And it can be done if you try to pull it out with a winch, truck or anything else are going to be circles or U-shaped. they're not going to come out very easy. But that's how I've done it over and over again. Some of them are harder than others, and they'll have rust on the end. you'll end up having to knock off some of the rust to get it to go through this head.

And, that's what you do there. Use a pipe wrench and you twist and hold it. Hold, pulled up on it at the same time. That's because you're Americans. Yep. You're not a Americant’s. You're Americans. See you guys.