Testing the Bear Creek Arsenal M4 Profile .223 Wylde 1:9 Twist Barrel

The following is a brief look at the following Bear Creek Arsenal Barrel:

Model: 1683-B223WCM41619(M)

Length: 16"
Caliber: .223 Wylde
Rifling Twist Rate: 1:9
Gas System Length: Carbine
Barrel Profile: M4
Feed Ramps: M4
Barrel Material: 4150 CMV
Finish: Melonite

Groups shown were shot from a concrete bench, with front and rear sandbag rests.

Range conditions:
Temperature: 40F
Wind: 5 MPH

Barrel was cleaned before shooting.

Build notes:

-Upper receiver was lapped and squared prior to assembly.
-Standard Handguards. Barrel is NOT free-floating
-Barrel extension and upper receiver had a tight interference fit.
-Barrel nut was torqued and loosened 3x before final torque value of 80 ft/lbs was applied.
-Gas block was aligned properly, and taper pinned.
-Muzzle device used a crush washer, but was pre-crushed before installation so that it could be installed only 1/8th of a turn past hand tight.

Lower receiver has a polished, adjusted, trigger that breaks cleanly at 5.5 lbs.

As with all videos I post, I'm not sponsored in any way by anybody or any entity. I'm just a guy who likes to test cheap barrels.

All weapons pictured are legally owned by me.
This review may not be indicative of every barrel bearing the same model. This is just my experience with this barrel.

Remember to like, share and subscribe! Thanks!