HHO REACTOR ATTACHMENT TORCH & WAND TECHNOLGY

Here we take a closer look at the highly advanced yet simple technology the oxyhydrogen reactor cores attachments handheld wands torch tips stove and parts assembly. Brass parts work perfectly along with mig welders tips fine bronze wool regular thread tape and some magic lube make building torches wands and any apparatus you can dream up or build simple and easy to do. Remeber to use a single valve to shut off and terminate oxyhydrogen flames as ball valves are too slow to stop flashbacks in high volume gas situations. The four inch flat pvc cap on the bottom was built by a company named ERA and the work very well and the clear pvc was purchased on ebay. Solid water tight seal was made using heavy duty pvc cement in combination along with J&B WELD QUIK to make a permanent seal and was allowed 2 to 3 days to dry completely before use or operation can proceed. Sand paper was used to clean the grey j&b quik up after drying to clean up the huge mess on the outside that it makes and great care was takin during the building process lots of sanding and careful construction of the light and the tools are very simple drill hacksaw dremel sandpaper bluetape benchgrinder etc....Work slow measure sand writing and numbers off the pvc make clean cuts use blue tape and build your project water tight using good amount of pvc glue in combination of J&B WELD QUIK!!! Also the bolts must be hand tighned in under pressure using thread tape and pvc glue along with a huge wrench to turn the bolt through the hole you drilled that is slightly smaller than the 3/8 bolt for the electrodes so they do not leak and the dremel cuts off the end of the bolt when you have it inside far enough use wet paper towel to keep bolt cool as it heats up when you cut it with dremel you dont want to melt the pvc..Remeber water tight take your time use the two glues sand wait for it to dry...ENJOY!!