Click to copy, then share by pasting into your messages, comments, social media posts and websites.
Click to copy, then add into your webpages so users can view and engage with this video from your site.
Report Content
We also accept reports via email. Please see the Guidelines Enforcement Process for instructions on how to make a request via email.
Thank you for submitting your report
We will investigate and take the appropriate action.
Testing the Bear Creek Arsenal 20" Nitride Treated .308 barrel
The following is a brief look at the following Bear Creek Arsenal Barrel:
Model: B308RMW20110(M)
Length: 20"
Caliber: .308 Winchester
Rifling Twist Rate: 1:10
Gas System Length: Rifle
Barrel Profile: SOCOM
Feed Ramps: AR10
Barrel Material: 4150 CMV
Finish: Nitride
Groups shown were shot from a concrete bench, with front and rear sandbag rests.
Range conditions:
Temperature: 30F
Wind: 5MPH Gusts
Barrel was cleaned before shooting. And after initial sight-in.
Build notes:
-Barrel was free floated.
-Barrel extension and upper receiver had a tight interference fit.
-Barrel nut was torqued and loosened 3x before final torque value.
-Gas block was aligned properly, and taper pinned.
-Muzzle device used a crush washer, but was pre-crushed before installation so that it could be installed only 1/16th of a turn past hand tight.
Lower receiver has a RA-140 Single stage trigger that breaks right at 4lbs.
As with all videos I post, I'm not sponsored in any way by anybody or any entity. I'm just a guy who likes to test cheap barrels.
All weapons pictured are legally owned by me.
This review may not be indicative of every barrel bearing the same model. This is just my experience with this barrel.
Complete build list:
- Aero Precision M5 upper and lower receiver
- Toolcraft Nitride treated bolt carrier group w/dual ejectors
- BCA 20" barrel
- Aero Precision R-One 15" MLOK handguard
- Aero Precision low profile gas block (taper pinned to barrel)
- Aero Precision Rifle length Melonite Gas Tube
- A2 muzzle device
- Aero precision lower parts kit
- Magpul MOE grip
- RA-140 Single stage 4lb drop in trigger
- UTG Pro A2 stock with buffer, buffer tube and spring
- Aero Precision Extended 30mm Ultra Lightweight scope mount
- Riton Mod-5 6-24x50 FFP scope
Remember to like, share and subscribe! Thanks!
Category | Sports & Fitness |
Sensitivity | Normal - Content that is suitable for ages 16 and over |
Playing Next
Testing the Bear Creek Arsenal M4 Profile .223 Wylde 1:9 Twist Barrel
4 years, 5 months ago
Related Videos
Haggling with the ATF over Braces
3 years, 4 months ago
3 years, 11 months ago
Accurizing the AR on the Cheap: how to adjust your trigger
4 years, 3 months ago
Testing the Bear Creek Arsenal .223 Wylde Lightweight barrel
4 years, 6 months ago
Testing the Bear Creek Arsenal 8.5" Mid-Weight 300 Blackout Barrel
4 years, 6 months ago
Warning - This video exceeds your sensitivity preference!
To dismiss this warning and continue to watch the video please click on the button below.
Note - Autoplay has been disabled for this video.