Making Copper Skull Coins & Future Giveaway Announcement.

GIVEAWAY ANNOUNCEMENT When I reach 100 Subs, I will do a giveaway. 44 Subs and climbing fast, So hit that SUBSCRIBE button and like those videos. In this video I tried my hand at making so sand cast copper skull coins. Had a few issues when ramming up the pattern in the flask, but over all it worked out. The coins were made 6mm tall, for some reason, one set didn't print out nowhere near that tall, I would luckily guess about half that, and even thinner on the In gate that I 3D printed with them all attached to the pattern and runner, I also used the Surge trap that Swdeeb and Paul's Garage use. You can get it here. https://www.myminifactory.com/object/3d-print-sand-casting-molding-tools-tapered-sprue-former-and-surge-trap-95674. I would say the overall success was pretty good. A little porosity, but at least they turned out pretty good. With them being skull coins, and being pulled from the depths of the ocean from a sunken pirate ship, they look good. (That's my story and I'm sticking to It).
Always remember safety, when dealing with Molten Metal.
Check out my other Videos:
https://www.youtube.com/channel/UCJd3i9jx9FVruNO6nPWJv9w/videos?view_as=subscriber

Be sure to like and subscribe if you liked the Videos.